Martel Releases Portable Pressure Calibrator with Integral Electrical Pump!
Dust Monitors
The S301 is designed as a filter bag leak detection monitor. Equipped with two independent alarm relays which can be used for early warning and failure, or connected to alarm-devices, it is used to detect filter deterioration and blockage or breakage. The alarms can be used for process control (as an ON-OFF system) in flow – no flow situations in bulk solids handling and pneumatic transport applications. Very fast response time, a typical charateristic of these monitors, enables early detection and prevention of expensive product loss to the environment.
The S303 also has a 4–20 mA analog signal output used for trend monitoring. It is installed downstream of a filter, cyclone, dryer, or similar devices to monitor the filter performance as well particulate emissions. It has two alarm relays which will energise when the amount of particulate in the gas stream exceeds a preset level. It can also be used for process control in certain applications. S301 and S303 are designed for use in any process fitted with bag, ceramic, or cartridge filters or cyclones where indicative (qualitative) monitoring is required.
S304– New Emission Monitor • Linear monitor for dust emission monitoring • Automatic range setup • Automatic drift compensation • Can be calibrated to mg/m3 (dust concentration) • Remote configuration using RS422 or RS485 • Remote data collection via Sintrol's data logging software
The S305 – New Stack Monitor with TÜV Certificate • Linear monitor for stack-monitoring applications • Automatic range setup • Automatic drift compensation • Can be calibrated to mg/m3 (dust concentraion) • Remote configuation and data collection using RS422 or RS485 • Self Zero check and self Span check
Visit the SINTROL Dust Monitors page for further information on this range of products
The 
The 
